65mm Downpipe Square Bend 90 Degree

Get a 65mm Square Downpipe Bend 90 Degree Here

This 90 degree downpipe bend is a simple push fit fitting that allows the installer to change the direction of the square downpipe at a right angle. It comes with a socket on one end (female) and a spigot on the other (male). It is simple to install and just pushes onto the downpipe. It does not require lubrication or sealant.

It’s often used on buildings with a wide soffit in place of an offset bend. It allows the installer to fit the pipe below the soffit rather than the downpipe dropping diagonally back to the wall as it usually would when using an offset bend.

Although commonly known as a 90 degree bend, it is actually 92.5 degrees which allows the water to run through it easily rather than pooling within the downpipe. The gradual bend also helps to stop blockages, which would often occur with a tight 90 degree bend.

Available in white, anthracite grey or black guttering.