Flexseal Internal Push Fit Coupling ICON4

Buy Flexseal Internal Push Fit Couplings ICON4 Online at EasyMerchant

The Icon Pushfit range consists of six variants designed to provide direct connections to DN100 pipes and DN150 pipes, or even to provide adaptors when DN100 pipes are linking to DN150 pipe sizes.

Flexseal Icon connections can be made to almost any pipe material via their inner surfaces. They are ideal installations for aboveground uses. The incorporated materials conform to the latest standards making them just as suitable for quick and easy below ground applications. When the Flexseal Icon is fitted the existing look of the pipework remains completely unchanged. In other words, it connects pipes almost invisibly.

For drainage applications, the coupling has specific design features that help to maintain the joint. It is resilient to the small increases in internal pressure within the width of the coupling as it connects pipes.

Note: The lip in the rubber is tapered to eliminate steps in the joint and help natural flow. This means they’re not reliably suited as a pipe service. The bored reduction has been kept to a minimum, which is deemed appropriate

The Icon pushfit is recommended for use where the external surface of a pipe is inaccessible and conventional couplings cannot, therefore, be used. Pipes of any material via their inner surfaces. The Flexseal 4″ Icon Pushfit range Includes 3 variations designed to Link DN100

Installation:

Step 1
Clean the internal surface of the pipe from slurry and debris.

Note: The lip in the rubber is tapered to eliminate steps in the joint and aid natural flow. Not suitable as a pipe support. Bored reduction has been kept to a minimum and is deemed suitable for drainage applications. The coupling has specific design features that help to keep the joint resilient to the very small increases in internal pressure over the width of the coupling.

Step 2
Push the Icon Pushfit into pipe 1 up to the product’s pipe stop.

Step 3
Push pipe 2 onto the opposite end of the Icon Pushfit

Benefits

• No need to expose the external surface of pipe
• Can be installed in 30 seconds or less
• A quick and easy alternative to standard coupling
• Superb connections to DN100 pipes and DN150 pipes
• Pushfit connection – no tools required
• Can be removed and re-used
• Watertight connection on any pipe material
• Connects pipes of differing or irregular outside diameters
• Pipe stop indicates that the product is properly installed, when it is flush to the pipe end
• Tested to 2.5bar inline pressure

Connects pipes of differing or irregular outside diameters

PRODUCT DATA SHEET

ICON DIFFERENCES