Purchase 116mm Deep Flow Stop End Here
If you have a particularly large roof, a heavily angled roof or a short run of guttering, you may find that the flow capacity of a standard half round gutter is not enough – a deep flow set up will give you the extra capacity that you need.
What is a gutter external stop end?
An external stop end designed for a deep flow system is a part that clips onto the end of a cut guttering run or a running outlet. It effectively ‘caps’ the end of the run or outlet off, preventing any water passing.
Fitting a high capacity gutter external stop end
It couldn’t be easier to fit an external stop end to a gutter length – no tools are needed and assuming you’re fitting it before you install the gutter, you don’t need to even work at height to get the job done.
With the end of the pipe you’re connecting to slightly chamfered, you can simply snap the external stop end cap into place. The lugs at the front and rear of the product locate over the guttering – then with a little pressure, the opposite side will clip into place.
Quickly watertight
Since the gutter external stop end has a built-in seal, there’s no need for any cement or fixings to ensure the connection is watertight. What’s more, the connection can be quickly separated should you need to clean or maintain the system.
Specifications: | |
Product Width: | 116mm |
Product Depth: | 77mm |
Gutter capacity with outlet in centre of run: | Gutter Level: 3.77 Litres/Sec 1:600 Gradient: 4.60 Litres/Sec |
Gutter capacity with outlet at end of run: | Gutter Level: 1.87 Litres/Sec 1:600 Gradient: 2.29 Litres/Sec |
Material: | uPVC |
Type: | 116mm Deep Flow Guttering |
Pack Size: | 1 |
Colours: | Black/White |
Product: | 116mm Deep Flow Stop End |
Connection: | Clip on |
Single Person Installation | Yes |
Manufacturer: | Freeflow |
Accreditations: | BS4576/ EN607/ EN1462 |
Weight: | 0.181Kg |
Please see Downloads tab for Gutter Compatibility Chart