110mm Soil Pipe Clip

Get a 110mm Soil Pipe Clip Online

Our 110mm soil pipe clips are an essential item if you’re securing soil pipes – either horizontally or vertically. At EasyMerchant, we appreciate that every job is a little different, so our clips are sold individually, meaning there’s no need to buy a full pack if you just need a single item to finish a job.

Fitting guidelines

These clips come pre-drilled with fixing holes at both sides. For vertical fittings, these pipe brackets should be used at a maximum of every 1.8m. For horizontal pipes, a maximum gap of 1m should be used.

Using a plumb-bob or laser level, you should mark the required position of the clips before constructing your push fit waste pipe stack. This allows for clear drilling access without the obstruction of the waste pipe. When your fixings are in place, you can then install your pipe and secure it with the required pipe clips. Unlike some pipe clips, the holes for fixings are outside the diameter of the pipe, so you’ll have no problem quickly securing your job.

When fitted, the gap between the soil pipe and the wall will be around 33mm-34mm, assuming you’re fitting to a flat surface.

Please note – these brackets do not come with the screws/fixings required to complete your job.

Specifications

Our soil pipe brackets are manufactured in the UK and come stamped with a Kitemark approval.

Clips are available in black and grey – and are therefore perfect for securing both 110mm plastic and 110mm cast-iron effect plastic soil and vent pipes.

We buy in bulk – so you don’t have to

At EasyMerchant, we purchase all of our products in large quantities – and that means we can pass on our savings to you. The result? Low cost pipe brackets that’ll be a long-lasting and reliable part of your soil pipe installation.