110mm Adjustable Downpipe Bend

Order 110mm Push Fit 90 Degree Downpipe Bends – Adjustable

If you find, when fitting your downpipe to your industrial guttering, that a standard downpipe angle just doesn’t work for avoiding obstacles in the way of taking the pipe to your drain, this double socket adjustable bend can be altered to create a range of angles – between 0-degrees and 90-degrees.

Fitting an adjustable bend

• Ensure that the plain ends of your 110mm downpipe have been cut, chamfered and lubricated appropriately.
• Simply push the prepared plain end of the downpipe into the sockets of the bend until it is stopped by the internal shoulders. These are in place to ensure that you cannot push the pipe in so far that you hinder the adjustable bend.
• Undo the adjuster rings between the sections on the bend and adjust to the required angle. Once you have achieved the desired angle, re-tighten the adjuster rings to lock this in place. Once fitted, if you need to adjust further, you can simply repeat this process as the bend will remain watertight with the adjuster rings undone.