110mm Push Fit Soil Rubber Boss Adaptor

Purchase 110mm Push Fit Soil Rubber Boss Adaptors Online Here

Soil pipes permit the removal of waste or filthy water from baths, showers, bathrooms and sinks, while also allowing odours to be expelled over the structure through a stack vent, at a stage where the odour released won’t cause a nuisance. The pipe’s vents also allow air to the internal drainage system to have the ability to ease the process of aerobic sewer digestion, preventing a siphoning effect from happening, and allowing free flow of water.

It is the pipe that carries waste water down. The bathrooms and the soil pipe by means of a connector will connect together, and waste water from this property’s sinks, toilets, showers and appliances will be connected by the waste pipes into the 110mm soil pipe fittings by means of a boss connection.

Approved document H: Requires that the foot of a soil and vent stack should have as large a radius as possible, rather than less than 200mm at the centre line. 110mm soil pipes should finish at least 900mm over any opening within 3m and must be completed with a wire cage or other perforated cover. Soil and vent pipes must maintain sufficient downward slope in their length to keep fluids and fluids flowing freely towards the drain. If a downward incline is not feasible, a collection pit using a’sewer ejector’ pump could be installed. It’s frequently connected to the exterior of a construction (even though it may be fitted internally) and joins the underground drainage system to a point just over the amount of this roof gutter.

Soil pipe is sometimes called port pipe, as at roof level a port will be set up to permit air flow to the system, preventing a vacuum and releasing gasses and some other scents. . We maintain stock both push fit soil and solvent soil ranges in 110mm, in grey and black.